This file lists all important changes to ATS9360 Firmware
[21.06] - 2018-07-23
- Added logic to support data skipping with sept source lasers.
- Fixed bug in DMA logic that could have DMA'd one packet of bad data at the start of DMA.
- Uses FFT v5.2 that fixes a bug in REAL_ONLY and IMAG_ONLY outputs.
- Timeout for NPT footer now runs on a fixed 50 MHz oscillator instead of the 250 MHz LCLK that can drift over time.
[20.10] - 2017-09-01
- Added a fixed clock based timestamp for k-clock based systems. Reg_15 must be set to ‘1’ to use this feature.
[20.09] - 2017-04-10
- Fixed CH B datapath in NRC module.
- Every other bit was connected to GND.
- This firmware Uses FFT 4.7.
[20.06] - 2017-04-06
- Fixed bug in Trigger Module that was missing internal triggers.
- Used hyst_off_level instead of level for hyst_ok.
[20.05] - 2017-03-22
- Made changes to Post trig end pulse so it occurs earlier. This allows almost zero re-arm time. This early re-arming works only for external triggering.
[20.03] - 2016-11-28
- Interleaved NPT footer in dual channel mode so after interleaving in dual channel mode, it will look the same as in single channel.
[20.01] - 2016-08-22
- Connected AUX_INPUT to REG_02. Previous firmware had this bit connected to '0', causing the Digital Input feature to not work.
[19.15] - 2016-04-26
- Disabled flushing of VFIFO at the end of Trigger Enable. This was causing data corruption problems.
[19.14] - 2016-04-21
- Used FFT core 4.5 that does fast zero-padding. Also reports dsp clk frequency, so sw can determine the max allowable trigger rate.
[19.10] - 2016-01-14
- Changed Frame Counter to not use CLK_EN. This was causing missed frame pulses if k-clock was not on when the frame start pulse occurred.
[19.09] - 2015-12-18
- Fixed NPT Pretrigger bug where the first record was not being captured properly if NPT pre-trigger was selected (slow ext clock en polarity was reversed).
[19.08] - 2015-12-02
- Increased VFIFO depth to 29. Previous depth was 27 which overflowed at 2GB instead of 8GB.
- Also implemented VFIFO protection mode that will not tell software VFIFO overflowed until all data has been DMA’d out of VFIFO.
[19.07] - 2015-11-17
- Increased NPT record length counter to be 2^28 instead of 2^24 in previous versions.